F3215-HP Load Balancing Module System Maintenance Configuration Guide-6PW101

59
Ste
p
Command Remarks
2. Enable traps
globally.
snmp-agent trap enable [ bgp | configuration |
default-route | flash | ospf [ process-id ] [ ifauthfail |
ifcfgerror | ifrxbadpkt | ifstatechange | iftxretransmit |
lsdbapproachoverflow | lsdboverflow | maxagelsa |
nbrstatechange | originatelsa | vifcfgerror | virifauthfail
| virifrxbadpkt | virifstatechange | viriftxretransmit |
virnbrstatechange ] * | pim [ candidatebsrwinelection |
electedbsrlostelection | interfaceelection |
invalidjoinprune | invalidregister | neighborloss |
rpmappingchange ] * | standard [ authentication |
coldstart | linkdown | linkup | warmstart ] * | system |
vrrp [ authfailure | newmaster ] ]
By default, the trap
function of all modules
is enabled.
3. Enter interface view.
interface interface-type interface-number N/A
4. Enable link state
traps.
enable snmp trap updown
By default, the link
state traps are
enabled.
Configuring the SNMP agent to send traps to a host
The SNMP module buffers the traps received from a module in a trap queue. You can set the size of the
queue, the duration that the queue holds a trap, and trap target (destination) hosts, typically the NMS.
To successfully send traps, you must also perform the following tasks:
• Complete the basic SNMP settings and verify that they are the same as on the NMS. If SNMPv1 or
SNMPv2c is used, you must configure a community name. If SNMPv3 is used, you must configure
an SNMPv3 user and MIB view.
• Make sure the device and the NMS can reach each other.
To configure the SNMP agent to send traps to a host:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Configure a target host.
snmp-agent target-host trap
address udp-domain ip-address
[ udp-port port-number ]
[ vpn-instance vpn-instance-name ]
params securityname
security-string [ v1 | v2c | v3
[ authentication | privacy ] ]
To send traps to a host, you must
perform this step to specify its IP
address.
The vpn-instance keyword is
applicable in an IPv4 network.
3. Configure the source address
for traps.
snmp-agent trap source
interface-type { interface-number |
interface-number.subnumber }
Optional.
By default, SNMP chooses the IP
address of an interface to be the
source IP address of traps.