F3215-HP Load Balancing Module System Maintenance Configuration Guide-6PW101

1: 1.3.6.1.2.1.1.5.0

Response binding:

1: Oid=sysName.0 Syntax=noSuchObject Value=NULL

Get finished

# Execute the shutdown or undo shutdown command on an idle interface on the agent. You can

see the interface state change traps on the NMS:

1.1.1.1/3374 V3 Trap = linkdown

SNMP Version = V3

Community = managev3user

Command = Trap

1.1.1.1/3374 V3 Trap = linkup

SNMP Version = V3

Community = managev3user

Command = Trap

SNMP logging configuration example

Network requirements

C o n f i g u r e t h e S N M P a g e n t (1.1.1.1 / 24 ) i n Figure 27 to log the SNMP operations performed by the NMS.

Figure 27 Network diagram

Configuration procedure

This example assumes that you have configured all required SNMP settings for the NMS and the agent

(see "SNMPv1/SNMPv2c configuration example" or "SNMPv3 configuration example").

# Ena

ble displaying log messages on the configuration terminal. (This function is enabled by default.

Skip this step if you are using the default.)

<Agent> terminal monitor

<Agent> terminal logging

# Enable the information center to output system information with severity level equal to or higher than

informational to the console port.

<Agent> system-view

[Agent] info-center source snmp channel console log level informational

# Enable logging GET and SET operations.

[Agent] snmp-agent log all

# Verify the configuration:

Use the NMS to get a MIB variable from the agent. The following is a sample log message displayed on

the configuration terminal: