F3215-HP Load Balancing Module System Maintenance Configuration Guide-6PW101

73
packets : 9 , broadcast packets : 2
multicast packets : 6 , CRC alignment errors : 0
undersize packets : 0 , oversize packets : 0
fragments : 0 , jabbers : 0
collisions : 0 , utilization : 0
Sampled values of record 7 :
dropevents : 0 , octets : 766
packets : 7 , broadcast packets : 0
multicast packets : 6 , CRC alignment errors : 0
undersize packets : 0 , oversize packets : 0
fragments : 0 , jabbers : 0
collisions : 0 , utilization : 0
Sampled values of record 8 :
dropevents : 0 , octets : 1154
packets : 13 , broadcast packets : 1
multicast packets : 6 , CRC alignment errors : 0
undersize packets : 0 , oversize packets : 0
fragments : 0 , jabbers : 0
collisions
: 0 , utilization : 0
# On the configuration terminal, get the traffic statistics through SNMP. (Details not shown.)
Alarm group configuration example
Network requirements
Configure the RMON alarm group on LB (the RMON agent) in Figure 31 to send alarms in traps when
the five-second incoming traffic statistic on GigabitEthernet 0/1 crosses the rising threshold or drops
below the falling threshold.
Figure 31 Network diagram
Configuration procedure
# Configure the SNMP agent with the same SNMP settings as the NMS at 1.1.1.2. This example uses
SNMPv1, read community public, and write community private.
<LB> system-view
[LB] snmp-agent
[LB] snmp-agent community read public
[LB] snmp-agent community write private
[LB] snmp-agent sys-info version v1