F3215-HP Load Balancing Module System Management Command Reference-6PW101

114
Views
System view
Default command level
3: Manage level
Parameters
ip-address: IP address of the NTP server. It must be a unicast address, rather than a broadcast address,
a multicast address or the IP address of the local clock.
server-name: Host name of the NTP server, which is a string of 1 to 20 characters.
authentication-keyid keyid: Specifies the key ID to be used for sending NTP messages to the NTP server,
where keyid is in the range of 1 to 4294967295.
priority: Specifies this NTP server as the first choice under the same condition.
source-interface interface-type interface-number: Specifies the source interface for NTP messages. In an
NTP message the local device sends to the NTP server, the source IP address is the primary IP address of
this interface. The interface-type interface-number argument represents the interface type and number.
version number: Specifies the NTP version, where number is in the range of 1 to 4 and defaults to 3.
Examples
# Designate NTP server 10.1.1.1 for the device, and configure the device to run NTP version 3.
<Sysname> system-view
[Sysname] ntp-service unicast-server 10.1.1.1 version 3