F3215-HP Load Balancing Module System Management Command Reference-6PW101

145
Usage guidelines
Command levels include four privileges: visit (0), monitor (1), system (2), and manage (3). You can
assign a privilege level according to the user's need. When logging in to the device, the user can access
the assigned level and all levels below it. For more information about command levels, see the chapter
on CLI in System Management Configuration Guide.
Inappropriate use of this command can cause maintenance, operation, and security problems. Make
sure you understand the impact of this command on your network before you use it.
The command specified for the command-privilege command must be complete, and have valid
parameters. For example, the default level of the tftp server-address { get | put | sget } source-filename
[ destination-filename ] [ source { interface interface-type interface-number | ip source-ip-address } ]
command is 3. After the command-privilege level 0 view s h e l l t f t p 1.1.1.1 p u t a . c f g c o m m a n d i s e x e c u t e d ,
when users with the user privilege level of 0 log in to the device, they can execute the tftp server-address
put source-filename command (such as tftp 192.168.1.26 put syslog.txt), but cannot execute the
command with the get, sget or source keyword, and cannot specify the destination-filename argument.
The command specified for the undo command-privilege view command can be incomplete. For
example, after the undo command-privilege view system ftp command is executed, all commands
starting with the keyword ftp (such as ftp server acl, ftp server enable, and ftp timeout) are restored to
their default level. If you have modified the level of commands ftp server enable and ftp timeout, and you
want to restore only the ftp server enable command to its default level, use the undo command-privilege
view system ftp server command.
If you modify the command level of a command in a specified view from the default command level to a
lower level, you must modify the command levels of the qu
i
t command and the command used to enter
this view. For example, the default command level of commands interface and system-view is 2 (system
level). If you want to make the interface command available to the level 1 users, execute the following
three commands: command-privilege level 1 view shell system-view, command-privilege level 1 view
system interface gigabitethernet 0/1, and command-privilege level 1 view system quit. Then, the level 1
users can enter system view, execute the interface gigabitethernet command, and return to user view.
Examples
# Set the command level of the interface command to 0 in system view.
<Sysname> system-view
[Sysname] command-privilege level 0 view system interface
display clipboard
Use display clipboard to display data in the clipboard.
Syntax
display clipboard [ | { begin | exclude | include } regular-expression ]
Views
Any view
Default command level
1: Monitor level
Parameters
|: Filters command output by specifying a regular expression. For more information about regular
expressions, see System Management Configuration Guide.