F3215-HP Load Balancing Module System Management Command Reference-6PW101

76
Syntax
reset unused porttag
Views
User view
Default command level
1: Monitor level
Usage guidelines
A confirmation is required when you execute this command. The command will not run if you enter N to
cancel the operation or fail to make a confirmation within 30 seconds.
Examples
# Clear unused 16-bit interface indexes.
<Sysname> reset unused porttag
Current operation will delete all unused port tag(s). Continue? [Y/N]:y
<Sysname>
schedule job
Use schedule job to schedule a job in the non-modular approach.
Use undo schedule job to remove the scheduled job.
Syntax
schedule job { at time1 [ date ] | delay time2 } view view-name command
undo schedule job
Views
User view
Default command level
3: Manage level
Parameters
at time1 [ date ]: Specifies the time and/or date to execute a command.
• time1: Sets time to execute the command, in the hh:mm format. The hh value ranges from 0 to 23,
and the mm value ranges from 0 to 59.
• date: Sets the date to execute the command, in the MM/DD/YYYY or YYYY/MM/DD format. The
YYYY value ranges from 2000 to 2035, the MM value ranges from 1 to 12, and the DD value
ranges from 1 to 31.
delay time2: Runs the job after a delay. The time2 argument specifies the delay in one of the following
formats:
• hh:mm format—The hh value ranges from 0 to 720, and the mm value ranges from 0 to 59. When
the hh value is 720, the mm value cannot be more than 0.
• mm format—It ranges from 0 to 432000 minutes, with 0 indicating that the command is executed
immediately.
view view: Specifies the view in which the command is executed. The view argument represents the view
name, and it can take only one of the following keywords: