F3215-HP Load Balancing Module System Management Command Reference-6PW101

77
• shell—Represents user view.
• system—Represents system view.
command: Command to execute.
Usage guidelines
You can schedule a job to automatically run a command or a set of commands without administrative
interference. The commands in a job are polled every minute. When the scheduled time for a command
is reached, the job automatically executes the command. If a confirmation is required while the
command is running, the system automatically enters Y or Yes. If characters are required, the system
automatically enters a default character string or an empty character string when no default character
string is available.
Follow these guidelines when you schedule a job in the non-modular approach:
• You can schedule only one job and run only one command in this approach. If you perform the
schedule job command multiple times, the last configuration takes effect.
• To have the command successfully executed, check that the specified view and command are valid.
The system does not verify their validity.
• If you specify both the time1 and date arguments, the execution time or date must be later than the
current system time or date.
• If you specify the time1 argument, but not the date argument:
{ When time1 is earlier than the current system time, the command runs at time1 the next day.
{ When time1 is later than the current system time, the command runs at time1 of the current day.
• The interval between the scheduled time and the current system time cannot exceed 720 hours, or
30 days.
• Changing any clock setting can cancel the job set by using the schedule job command.
• After job execution, the configuration interface, view, and user status that you have before job
execution restore even if the job has run a command that changes the user interface (for example,
telnet, ftp, and ssh2), the view (for example, system-view and quit), or the user status (for example,
super).
Examples
# Schedule a job to execute the batch file 1.bat in system view in 60 minutes (assuming that the current
time is 11: 4 3 ) .
<Sysname> schedule job delay 60 view system execute 1.bat
Info: Command execute 1.bat in system view will be executed at 12:43 10/31/2012 (in 1 hours
and 0 minutes).
# Schedule a job to execute the batch file 1.bat in system view at 12:00 (assuming that the current time
is 11: 4 3 ) .
<Sysname> schedule job at 12:00 view system execute 1.bat
Info: Command execute 1.bat in system view will be executed at 12:00 10/31/2012 (in 0 hours
and 16 minutes).
schedule reboot at
Use schedule reboot at to schedule a device reboot to occur at a specific time and date.
Use undo schedule reboot to disable the scheduled reboot function.