F3215-HP Load Balancing Module System Management Configuration Guide-6PW101

This chapter describes the available login methods and their configuration procedures.

For the first login, you can connect a terminal to the console port of the LB module to access the CLI or

use the username admin and password admin to access the Web interface of the LB module. After login,

you can configure other login methods, such as Telnet and SSH for remote access.

Table 1 Login methods

in method Default settin

and confi

uration re

uirements

Logging in to the CLI:

• Logging in through the console

port for the first time

By default, login through the console port is enabled, no username or

password is required, and the user privilege level is 3.

• Logging in through Telnet

By default, Telnet service is disabled. To use Telnet service, complete

the following configuration tasks:

• Enable the Telnet server function.

• Assign an IP address to a Layer 3 interface and make sure the

interface and the Telnet client can reach each other. By default, the

LB module has the IP address 192.168.0.1/24 configured for the

interface GigabitEthernet 0/1.

• Configure the authentication mode for VTY login users (scheme by

default).

• Configure the user privilege level of VTY login users (0 by default).

• Logging in through SSH

By default, SSH service is disabled. To use SSH service, complete the

following configuration tasks:

• Enable the SSH server function and configure SSH attributes.

• Assign an IP address to a Layer 3 interface and make sure the

interface and the SSH client can reach each other. By default, the

LB module has the IP address 192.168.0.1/24 configured for the

interface GigabitEthernet 0/1.

• Enable scheme authentication for VTY login users (scheme by

default).

• Configure the user privilege level of VTY login users (0 by default).

Logging in to the Web interface

By default, you can log in to the Web interface with the IP address

192.168.0.1/24, username admin, and password admin. (By

default, the LB module has the IP address 192.168.0.1/24

configured for the interface GigabitEthernet 0/1.)