F3215-HP Load Balancing Module System Management Configuration Guide-6PW101

121
Reference time: 14:53:27.371 UTC Sep 19 2012 (C6D94F67.5EF9DB22)
The output shows that Device B has synchronized to Device A. The stratum level of Device B is 3,
and that of Device A is 2.
# Display NTP session information for Device B, which shows that an association has been set up
between Device B and Device A.
[DeviceB] display ntp-service sessions
source reference stra reach poll now offset delay disper
**************************************************************************
[12345] 1.0.1.11 127.127.1.0 2 63 64 3 -75.5 31.0 16.5
note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured
Total associations : 1
NTP symmetric peers mode configuration example
Network requirements
Perform the following configurations to synchronize time among devices:
• As shown in Figure 78, the loca
l clock of LB A is to be configured as a reference source, with the
stratum level 2.
• The local clock LB C is to be configured as a reference source, with the stratum level 1.
• LB B operates in client mode and LB A is to be used as the NTP server of LB B.
• LB C operates in symmetric-active mode and LB B acts as the peer of LB C.
Figure 78 Network diagram
Configuration procedure
• Set the IP address for each interface as shown in Figure 78. (Details not shown.)
• Configure LB A:
# Specify the local clock as the reference source, with the stratum level 2.
<LBA> system-view
[LBA] ntp-service refclock-master 2
• Configure LB B:
# Specify LB A as the NTP server of LB B.
LB A
NTP server
LB B
NTP client/
symmetric passive peer
LB C
Symmetric active peer
3.0.1.31/24
3.0.1.32/24 3.0.1.33/24