F3215-HP Load Balancing Module System Management Configuration Guide-6PW101

17
Ste
p
Command Remarks
5. Configure the
command level for
login users on the
current user interfaces.
user privilege level level
By default, the default command level is 0 for
VTY user interfaces.
6. Configure common
settings for the VTY
user interfaces.
See "Configuring common VTY
user interface settings
(optional)."
Optional.
The next time you attempt to Telnet to the LB module, you do not need to provide any username or
password, as shown in Figure 14. If the ma
ximum number of login users has been reached, your login
attempt fails and the message "All user interfaces are used, please try later!" appears.
Figure 14 Telnetting to the LB module without authentication
Configuring password authentication for Telnet login
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable Telnet server.
telnet server enable
By default, the Telnet server
function is disabled.
3. Enter one or multiple VTY
user interface views.
user-interface vty first-number
[ last-number ]
N/A
4. Enable password
authentication.
authentication-mode password
By default, scheme
authentication is enabled for
VTY user interfaces.