F3215-HP Load Balancing Module System Management Configuration Guide-6PW101

Ste

Command

Remarks

5. Set a password.

set authentication password [ hash ]

{ cipher | simple } password

By default, no password is set.

6. Configure the user privilege

level for login users.

user privilege level level The default level is 0.

7. Configure common settings

for VTY user interfaces.

See "Configuring common VTY user

interface settings (optional)."

Optional.

The next time you attempt to Telnet to the LB module, you must provide the configured login password, as

shown in Figure 15. If the ma

ximum number of login users has been reached, your login attempt fails and

the message "All user interfaces are used, please try later!" appears.

Figure 15 Password authentication interface for Telnet login

Configuring scheme authentication for Telnet login

When scheme authentication is used, you can choose to configure the command authorization and

command accounting functions.

If command authorization is enabled, a command is available only if the user has the commensurate user

privilege level and is authorized to use the command by the AAA scheme.

Command accounting allows the HWTACACS server to record all commands executed by users,

regardless of command execution results. This function helps control and monitor user behaviors on the

LB module. If command accounting is enabled and command authorization is not enabled, every

executed command is recorded on the HWTACACS server. If both command accounting and command

authorization are enabled, only the authorized and executed commands are recorded on the

HWTACACS server.

Follow these guidelines when you configure scheme authentication for Telnet login: