F3215-HP Load Balancing Module System Management Configuration Guide-6PW101

20
Ste
p
Command Remarks
10. Set a password.
password [ [ hash ] { cipher |
simple } password ]
By default, no password is set.
11. Specify the command
level of the local user.
authorization-attribute level level
Optional.
By default, the command level is 0.
12. Specify Telnet service for
the local user.
service-type telnet By default, no service type is specified.
13. Exit to system view.
quit N/A
14. Configure common
settings for VTY user
interfaces.
See "Configuring common VTY user
interface settings (optional)."
Optional.
The next time you attempt to Telnet to the CLI, you must provide the configured login username and
password, as shown in Figure 16. If yo
u are required to pass a second authentication, you must also
provide the correct password to access the CLI. If the maximum number of login users has been reached,
your login attempt fails and the message "All user interfaces are used, please try later!" appears.
Figure 16 Scheme authentication interface for Telnet login
Configuring common VTY user interface settings (optional)
You might be unable to access the CLI through a VTY user interface after configuring the auto-execute
command command on it. Before you configure the command and save the configuration, make sure you
can access the CLI through a different user interface.
To configure common settings for VTY user interfaces: