F3215-HP Load Balancing Module System Management Configuration Guide-6PW101

30
Ste
p
Command Remarks
9. Configure a password for the
local user.
password [ [ hash ] { cipher |
simple } password ]
By default, no password is
configured for a newly created
local user, and the password for
local user admin is admin.
10. Specify the command level of
the local user.
authorization-attribute level level
No command level is configured
for the local user.
11. Specify the Telnet service type
for the local user.
service-type web
By default, no service type is
configured for the local user.
12. Exit to system view.
quit N/A
13. Enter interface view.
interface interface-type
interface-number
N/A
14. Assign an IP address and
subnet mask to the interface.
ip address ip-address { mask |
mask-length }
By default, the interface
GigabitEthernet 0/1 on the LB
module has the IP address
192.168.0.1/24 configured.
Configuring HTTPS login
The LB module supports the following HTTPS login modes:
• Simplified mode—To make the LB module operate in this mode, you only need to enable HTTPS
service on the LB module. The LB module will use a self-signed certificate (a certificate that is
generated and signed by the LB module itself, rather than a CA) and the default SSL settings. This
mode is simple to configure but has potential security risks.
• Secure mode—To make the LB module operate in this mode, you must enable HTTPS service on the
LB module, specify an SSL server policy for the service, and configure PKI domain-related
parameters. This mode is more complicated to configure but provides higher security.
For more information about SSL and PKI, see Security Configuration Guide.
To configure HTTPS login:
Ste
p
Command Remarks
1. Specify a fixed verification
code for Web login.
web captcha verification-code
Optional.
By default, a Web user must enter the
verification code indicated on the login
page to log in.
This command is available in user view.
2. Enter system view.
system-view N/A