F3215-HP Load Balancing Module System Management Configuration Guide-6PW101

41
Ste
p
Command Remarks
3. Configure an SNMP
group and specify its
access right.
snmp-agent group v3 group-name
[ authentication | privacy ]
[ read-view read-view ] [ write-view
write-view ] [ notify-view
notify-view ] [ acl acl-number | acl
ipv6 ipv6-acl-number ] *
By default, no SNMP group is
configured.
4. Add a user to the SNMP
group.
snmp-agent usm-user v3 user-name
group-name [ [ cipher ]
authentication-mode { md5 | sha }
auth-password [ privacy-mode
{ 3des | aes128 | des56 }
priv-password ] ] [ acl acl-number |
acl ipv6 ipv6-acl-number ] *
N/A
Configuring SNMPv1 or SNMPv2c settings
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enable the SNMP
agent.
snmp-agent
Optional.
By default, the SNMP agent
is disabled.
You can enable SNMP agent
with this command or any
command that begins with
snmp-agent (except for
snmp-agent
calculate-password).
3. Create or update
MIB view
information.
snmp-agent mib-view { excluded | included }
view-name oid-tree [ mask mask-value ]
Optional.
By default, the MIB view
name is ViewDefault and
OID is 1.
4. Configure the SNMP
access right.
• (Approach 1) Specify the SNMP NMS access
right directly by configuring an SNMP
community:
snmp-agent community { read | write }
community-name [ mib-view view-name ] [ acl
acl-number | acl ipv6 ipv6-acl-number ] *
• (Approach 2) Configure an SNMP group and
add a user to the SNMP group:
a. snmp-agent group { v1 | v2c }
group-name [ read-view read-view ]
[ write-view write-view ] [ notify-view
notify-view ] [ acl acl-number | acl ipv6
ipv6-acl-number ] *
b. snmp-agent usm-user { v1 | v2c }
user-name group-name [ acl acl-number
| acl ipv6 ipv6-acl-number ] *
Use either approach.
The username in approach 2
is equivalent to the
community name used in
approach 1, and must be the
same as the community name
configured on the NMS.