F3215-HP Load Balancing Module System Management Configuration Guide-6PW101

60
Configuring the maximum number of concurrent
users
You can configure this command to limit the number of users that can enter the system view
simultaneously. When the number of concurrent users reaches the upper limit, other users cannot enter
system view.
When multiple users configure a setting in system view, only the last configuration applies.
To configure the maximum number of concurrent users:
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Configure the maximum
number of concurrent users.
configure-user count number
By default, up to two users can
perform operations in system view
at the same time.
Configuring the exception handling method
You can configure the device to handle system exceptions in one of the following methods:
• reboot—The device automatically reboots to recover from the error condition.
• maintain—The device stays in the error condition so you can collect complete data, including error
messages, for diagnosis. In this approach, you must manually reboot the device.
To configure the exception handling method:
Ste
p
Command Remarks
1. Enter system view. system-view N/A
2. Configure the exception
handling method for the
system.
system-failure { maintain | reboot }
By default, the system uses the
reboot method when an exception
occurs.
Rebooting the device
CAUTION:
• Device reboot can interrupt network services.
• To avoid data loss, save the current configuration before a reboot.
To restore the device from an error condition or place new software loaded to the device into effect, you
might need to reboot the device.
To reboot the device, use one of the following methods:
• Reboot the device immediately in the Web interface or at the CLI.
• At the CLI, schedule a reboot to occur at a specific time and date or after a delay.