F3215-HP Load Balancing Module System Management Configuration Guide-6PW101

74
Ste
p
Command Remarks
3. Configure the password for
the user privilege level.
super password [ level user-level ]
{ cipher | simple } password
If local authentication is involved,
this step is required.
By default, a privilege level has no
password.
If no user privilege level is specified
when you configure the command,
the user privilege level defaults to
3.
If local-only authentication is used, a console user interface user can switch to a higher privilege level,
even if the privilege level has not been assigned a password.
Switching to a higher user privilege level
Before you switch to a higher user privilege level, obtain the required authentication data as described
in Table 17.
Th
e privilege level switching fails after three consecutive unsuccessful password attempts.
To switch the user privilege level, perform the following task in user view:
Task Command Remarks
Switch the user privilege level. super [ level ]
When logging in to the device, a
user has a user privilege level,
which depends on user interface or
authentication user level.
Table 17 Information required for user privilege level switching
User interface
authentication
mode
User privilege
level switching
authentication
mode
Information required for the
first authentication mode
Information required for the
second authentication mode
none/password
local
Password configured for the
privilege level on the device with
the super password command.
N/A
local scheme
Password configured for the
privilege level on the device with
the super password command.
Username and password
configured on the AAA server for
the privilege level.
scheme
Username and password for the
privilege level.
N/A
scheme local
Username and password for the
privilege level.
Local user privilege level
switching password.
scheme local
Password configured for the
privilege level on the device with
the super password command.
N/A