F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Access Control Command Reference-6PW100

135
If you configure the user synchronization function for a portal server for multiple times, the last
configuration takes effect. If you do not specify an optional parameter, the default setting of the
parameter is used.
For redundant user information on the device—information of the users considered as nonexistent on the
portal server, the device deletes the information during the (N+1)th probe interval, where N equals to the
value of retries configured in the portal server user-sync command.
Examples
# Configure the device to synchronize portal user information with portal server pts:
• Setting the synchronization probe interval to 600 seconds
• Specifying the device to log off users if information of the users does not exist in the user
synchronization packets sent from the server in two consecutive probe intervals.
<Sysname> system-view
[Sysname] portal server pts user-sync interval 600 retry 2
reset portal connection statistics
Use reset portal connection statistics to clear portal connection statistics on a specific interface or all
interfaces.
Syntax
reset portal connection statistics { all | interface interface-type interface-number }
Views
User view
Default command level
1: Monitor level
Parameters
all: Specifies all interfaces.
interface interface-type interface-number: Specifies an interface by its type and number.
Examples
# Clear portal connection statistics on interface GigabitEthernet 0/1.
<Sysname> reset portal connection statistics interface gigabitethernet 0/1
reset portal server statistics
Use reset portal server statistics to clear portal server statistics on a specific interface or all interfaces.
Syntax
reset portal server statistics { all | interface interface-type interface-number }
Views
User view
Default command level
1: Monitor level