F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Access Control Command Reference-6PW100

216
[Sysname-radius-radius1] security-policy-server 10.110.1.2
server-type (RADIUS scheme view)
Use server-type to specify the RADIUS server type.
Use undo server-type to restore the default.
Syntax
server-type { extended | standard }
undo server-type
Default
The supported RADIUS server type is standard.
Views
RADIUS scheme view
Default command level
2: System level
Parameters
extended: Specifies the extended RADIUS server (generally running on IMC), which requires the RADIUS
client and RADIUS server to interact according to the procedures and packet formats provisioned by the
proprietary RADIUS protocol.
standard: Specifies the standard RADIUS server, which requires the RADIUS client and RADIUS server to
interact according to the procedures and packet format of the standard RADIUS protocol (RFC 2865 and
2866 or their successors).
Examples
# Configure the RADIUS server type of RADIUS scheme radius1 as standard.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] server-type standard
state primary
Use state primary to set the status of a primary RADIUS server.
Syntax
state primary { accounting | authentication } { active | block }
Default
The primary RADIUS server specified for a RADIUS scheme is in active state.
Views
RADIUS scheme view
Default command level
2: System level
Parameters
accounting: Sets the status of the primary RADIUS accounting server.