F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Access Control Command Reference-6PW100

29
rule 10 permit source 192.168.0.0 0.0.0.255
rule 15 permit source 1.1.1.1 0
rule 20 permit source 10.1.1.1 0
rule 25 permit counting
rule 26 remark Rules for VIP_end
#
return
Related commands
• display this
• display current-configuration (System Management and Maitenance Command Reference)
step
Use step to set a rule numbering step for an ACL. The rule numbering step sets the increment by which the
system numbers rules automatically. For example, the default ACL rule numbering step is 5. If you do not
assign IDs to rules you are creating, they are numbered 0, 5, 10, 15, and so on. The wider the numbering
step, the more rules you can insert between two rules. Whenever the step changes, the rules are
renumbered, starting from 0. For example, if there are five rules numbered 5, 10, 13, 15, and 20,
changing the step from 5 to 2 causes the rules to be renumbered 0, 2, 4, 6, and 8.
Use undo step to restore the default.
Syntax
step step-value
undo step
Default
The rule numbering step is 5.
Views
IPv4 basic/advanced ACL view, IPv6 basic/advanced ACL view, Ethernet frame header ACL view
Default command level
2: System level
Parameters
step-value: ACL rule numbering step, in the range of 1 to 20.
Usage guidelines
After you restore the default numbering step by using the undo step command, the rules are renumbered
in steps of 5.
Examples
# Set the rule numbering step to 2 for IPv4 basic ACL 2000.
<Sysname> system-view
[Sysname] acl number 2000
[Sysname-acl-basic-2000] step 2
# Set the rule numbering step to 2 for IPv6 basic ACL 2000.
<Sysname> system-view
[Sysname] acl ipv6 number 2000