F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Access Control Configuration Guide-6PW100

7
Figure 3 List of IPv4 basic ACL rules
3. Click Add to enter the IPv4 basic ACL rule configuration page.
Figure 4 IPv4 basic ACL rule configuration page
4. Configure a rule as described in 556HTable 3.
5. Click Apply.
Table 3 Configuration items
Item Descri
p
tion
Rule ID
Select the Rule ID box, and enter a number for the rule.
If you do not specify a rule number, the system automatically assigns one to the rule.
If the rule already exists, the configuration overwrites the old rule.
Operation
Select the operation to be performed for packets matching the rule:
• Permit—Allows matching packets to pass.
• Deny—Denies matching packets.
Time Range
Select a time range for the rule.
If you select None, the rule is always effective.
Available time ranges are configured by selecting Resource > Time Range from the
navigation tree.
Non-first Fragments
Only
Select this box to apply the rule to only non-first fragments. If you do not select this box,
the rule applies to all packets (including non-fragment packets and each fragment).
Selecting this box improves the ACL rule matching efficiency.