F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Access Control Configuration Guide-6PW100

248
Item Descri
p
tion
Accounting-On Attempts
Set the maximum number of accounting-on packets transmission attempts.
This field is configurable only when the Send accounting-on packets box is
selected.
• Attribute
• Interpretation
Enable or disable the device to interpret the RADIUS class attribute as CAR
parameters.
7. In the RADIUS Server Configuration area, click Add.
Figure 154 RADIUS server configuration page
8. Configure the RADIUS server parameters, as described in 772HTable 55.
9. Click Apply.
Table 55 Configuration items
Item Descri
p
tion
Server Type
Select the type of the RADIUS server to be configured. Options include primary
authentication server, primary accounting server, secondary authentication server, and
secondary accounting server.
IP Address
Specify the IP address of the RADIUS server.
Support for IPv6 addresses depends on the device model. For more information, see
Network Management Configuration Guide.
Port Specify the UDP port of the RADIUS server.
• Key
• Confirm Key
Specify the shared key for communication with the RADIUS server.
If no shared key is specified here, the shared key specified in the common configuration
part is used.
VPN
Specify the VPN to which the RADIUS server belongs.
If no VPN is specified here, the VPN specified in the common configuration part is used.
10. To configure more RADIUS servers for the RADIUS scheme, repeat steps 7 through 9.
11. Click Apply on the RADIUS scheme configuration page.
477BConfiguration guidelines
When you configure RADIUS, follow these guidelines: