F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Access Control Configuration Guide-6PW100

{ Create security zones to which you will apply an interzone policy (see "Configuring security

zones").

{ Configure IPv4 advanced ACLs (see "Configuring ACLs").

2. Configuration procedure

To configure an interzone policy group:

{ Select Firewall > Security Policy > Interzone Policy Group from the navigation tree to enter the

interzone policy group list page.

Figure 74 Interzone policy group list

Table 25 Operations you can perform on the list

Field O

eration

Referenced ACLs

Click an ACL to enter the ACL configuration page, where you can view, create, and

delete rules in the ACL. For information about ACL configuration, see "Configuring ACLs."

Status

• shows that the interzone policy group is enabled. Click Disable to disable the

interzone policy group.

• shows that the interzone policy group is disabled. Click Enable to enable the

interzone policy group.

NOTE:

The "Match Counter" field refers to the number of times that the interzone policy rule has been matched.

Click Clear match counter to clear the match counters of all interzone policy rules and interzone policy

groups.

{

Then click Add to enter the interzone policy group configuration page.