F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Access Control Configuration Guide-6PW100

85
Before configuring an interzone policy group, complete the following tasks:
{ Create security zones to which you will apply an interzone policy (see "Configuring security
zones").
{ Configure IPv6 basic or IPv6 advanced ACLs (see "Configuring ACLs").
• Configuration procedure
{ Select Firewall > Security Policy > IPv6 Interzone Policy Group from the navigation tree to enter
the interzone policy group list page.
Figure 76 IPv6 interzone policy group
Table 27 Operations you can perform on the list
Field O
p
eration
Referenced ACLs
Click an ACL to enter the ACL configuration page, where you can view, create, and
delete rules in the ACL. For information about ACL configuration, see "Configuring ACLs."
Status
• shows that the interzone policy group is enabled. Click Disable to disable the
interzone policy group.
• shows that the interzone policy group is disabled. Click Enable to enable the
interzone policy group.
Match Counter
The "Match Counter" field refers to the number of times that the interzone policy rule has
been matched. Click Clear match counter to clear the match counters of all interzone
policy rules and interzone policy groups.
{ Then click Add to enter the IPv6 interzone policy group configuration page.