F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Access Control Configuration Guide-6PW100

Figure 77 Adding an IPv6 interzone policy group

{ Configure the interzone policy group as described in 619HTable 28.

{ Click Apply.

Table 28 Configuration items

Item Descri

tion

Source Zone

Select a source zone for the interzone policy group.

Any means all zones on the virtual device.

Dest Zone

Select a destination zone for the interzone policy group.

Any means all zones on the virtual device. Virtual device name-Any means all shared

zones on the virtual device with the specified name.

If you specify a zone, instead of Any, for Source Zone, do not specify Any or Virtual

device name-Any for Dest Zone.

Selected ACLs

Select the IPv6 basic ACLs and IPv6 advanced ACLs to be referenced by the interzone

policy group.

The selected ACLs are listed in the order they are selected, which is also the match order.

An ACL listed earlier has a higher priority, and is matched earlier.

For any ACL referenced by an interzone policy group, only the five tuples (source IP

address, destination IP address, source port, destination port, and protocol type) are

used.

Enable Select this box to enable interzone policy group settings.