F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Attack Protection Command Reference-6PW100

51
Field Descri
p
tion
Inspect
Number of ARP packets that failed to pass ARP detection (based on static IP Source
Guard binding entries/DHCP snooping entries/802.1X security entries/OUI MAC
addresses).
reset arp detection statistics
Use reset arp detection statistics to clear ARP detection statistics of a specific interface. If you do not
specify any interface, this command clears the statistics of all interfaces.
Syntax
reset arp detection statistics [ interface interface-type interface-number ]
Views
User view
Default command level
1: Monitor level
Parameters
interface interface-type interface-number: Clears the ARP detection statistics of a specific interface.
Examples
# Clear the ARP detection statistics of all interfaces.
<Sysname> reset arp detection statistics
ARP automatic scanning and fixed ARP
configuration commands
arp fixup
Use arp fixup to change the existing dynamic ARP entries into static ARP entries. You can use this
command again to change the dynamic ARP entries learned later into static.
Syntax
arp fixup
Views
System view
Default command level
2: System level
Usage guidelines
The static ARP entries changed from dynamic ARP entries have the same attributes as the manually
configured static ARP entries.
The number of static ARP entries changed from dynamic ARP entries is restricted by the number of static
ARP entries that the device supports. As a result, the device may fail to change all dynamic ARP entries
into static ARP entries.