F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Attack Protection Configuration Guide-6PW100

121
• Configure ACLs for special packets or users.
39B
Configuring the URPF in the Web interface
116BConfiguring URPF
1. From the navigation tree, select Intrusion Detection > URPF Check to enter the URPF check
configuration page, as shown in
422HFigure 100.
Figure 100 URPF check configuration page
2. Configure URPF settings for the security zone, as shown in 423HTable 24.
3. Click Apply.
Table 24 Configuration items
Item Descri
p
tion
Security Zone
Security zone where the URPF check is to be configured. URPF configuration takes
effect on all the interfaces in the security zone.
IMPORTANT:
URPF configuration takes effect on the packets received by the interfaces in the security
zone only.
Enable URPF
Enable/disable URPF check.
If this box is not selected, URPF check is disabled and the following parameters are
not configurable.
Allow Default Route Allow using the default route for URPF check.
ACL Reference an ACL.
Type of Check Set the URPF check type, Strict or Loose.
117BURPF configuration example
Either Device A or Device B in the configuration example can be used as a firewall.