F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Attack Protection Configuration Guide-6PW100

3. Click Add to enter the page for adding a Telnet filtering policy, as shown in 394HFigure 77.

Figure 77 Adding a Telnet filtering policy

4. Configure the Telnet filtering policy, as described in 395HTable 22.

5. Click Apply.

Table 22 Configuration items

Item Descri

tion

Name Specify the name for the Telnet filtering policy.

Command Filtering

Select the filtering entries to be used for command word filtering.

IMPORTANT:

• Packets that match these filtering conditions will be dropped.

• You must select at least one command word filtering entry for the

Telnet filtering policy.

Enable Logging

Specify whether to log packet matching events.

IMPORTANT:

The logging function takes effect only when it is enabled in both the content

filtering policy and the interzone policy.

106BConfiguring a content filtering policy template

You can configure a content filtering policy template in the content filtering module or in the interzone

policy module. The configuration items in the two modules are the same. This chapter describes the

policy template configuration in the content filtering module. For that in the interzone policy module, see

Access Control Configuration Guide.

1. From the navigation tree, select Identification > Content Filtering > Policy Template.

The policy template list page appears, as shown in

396HFigure 78.