F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices High Availability Command Reference-6PW100

125
Views
Ethernet interface view
Default command level
2: System level
Examples
# Set the LACP timeout interval on GigabitEthernet 0/1 to the short timeout interval (1 second).
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] lacp period short
lacp system-priority
Use lacp system-priority to set the LACP priority of the local system.
Use undo lacp system-priority to restore the default setting.
Syntax
lacp system-priority system-priority
undo lacp system-priority
Default
The system LACP priority is 32768.
Views
System view
Default command level
2: System level
Parameters
system-priority: Specifies the LACP priority of the local system, ranging from 0 to 65535. The smaller the
value, the higher the system LACP priority.
Examples
# Set the system LACP priority to 64.
<Sysname> system-view
[Sysname] lacp system-priority 64
link-aggregation load-sharing mode
Use link-aggregation load-sharing mode to configure the global or group-specific link-aggregation load
sharing criteria.
Use undo link-aggregation load-sharing mode to restore the default setting.
Syntax
link-aggregation load-sharing mode { { destination-ip | destination-port | ip-protocol | source-ip |
source-port } * | per-packet }
undo link-aggregation load-sharing mode