F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices High Availability Command Reference-6PW100

126
Default
The five tuples (source IP address, destination IP address, source port, destination port, and transport
protocol) are used for load sharing.
Views
System view, Layer 2 aggregate interface view, Layer 3 aggregate interface view
Default command level
2: System level
Parameters
destination-ip: Performs load sharing in link aggregation groups based on destination IP address.
destination-port: Performs load sharing in link aggregation groups based on destination port.
ip-protocol: Performs load sharing in link aggregation groups based on protocol type.
per-packet: Performs per-packet load sharing in link aggregation groups.
The following matrix shows the keyword per-packet and firewalls and UTM compatibility:
Hardware Ke
y
word com
p
atible
F1000-A-EI/F1000-S-EI No
F1000-E No
F5000 Yes
Firewall module No
U200-A No
U200-S No
source-ip: Performs load sharing in link aggregation groups based on source IP address.
source-port: Performs load sharing in link aggregation groups based on source port.
Usage guidelines
The load sharing criteria that you configure will overwrite the previous criteria.
If unsupported load sharing criteria are configured, an error prompt will appear.
Examples
# Configure the source IP address and destination IP address as the global link-aggregation load sharing
criteria.
<Sysname> system-view
[Sysname] link-aggregation load-sharing mode source-ip destination-ip
# Configure the destination IP address as the load sharing criterion specific to the link aggregation group
of aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation load-sharing mode destination-ip