F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices High Availability Command Reference-6PW100

129
Usage guidelines
Executing this command may cause some of the selected member ports in the aggregation group to
become unselected.
Make sure that the maximum number of Selected ports allowed in an aggregation group is the same as
that on the peer.
Examples
# Configure the maximum number of Selected ports allowed as 3 in the aggregation group
corresponding to Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation selected-port maximum 3
link-aggregation selected-port minimum
Use link-aggregation selected-port minimum to configure the minimum number of Selected ports in the
aggregation group.
Use undo link-aggregation selected-port minimum to restore the default setting.
Syntax
link-aggregation selected-port minimum number
undo link-aggregation selected-port minimum
Default
The minimum number of Selected ports in an aggregation group is not specified.
Views
Layer 2 aggregate interface view, Layer 3 aggregate interface view
Default command level
2: System level
Parameters
number: Specifies the minimum number of Selected ports in an aggregation group required to bring up
the aggregate interface.
The following matrix shows the link-aggregation selected-port minimum command firewalls and UTM
devices compatibility and the value range for the number argument on different firewalls and UTM
devices:
Hardware Command com
p
atibilit
y
Value ran
g
e
F1000-A-EI/F1000-S-EI Yes 1 to 4
F1000-E No N/A
F5000 Yes 1 to 8
Firewall module No N/A
U200-A Yes 1 to 4
U200-S No N/A