F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices High Availability Command Reference-6PW100

130
Usage guidelines
Executing this command may cause all the member ports in the aggregation group to become
unselected.
Make sure that the minimum number of Selected ports in an aggregation group is the same as that on the
peer.
Examples
# Configure the minimum number of Selected ports as 3 in the aggregation group corresponding to
Layer 2 aggregate interface Bridge-Aggregation 1.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] link-aggregation selected-port minimum 3
mtu
Use mtu to set the MTU of a Layer 3 aggregate interface or subinterface.
Use undo mtu to restore the default setting.
Syntax
mtu size
undo mtu
Default
The MTU for Layer 3 aggregate interfaces and subinterfaces is 1500 bytes.
Views
Layer 3 aggregate interface view, Layer 3 aggregate subinterface view
Default command level
2: System level
Parameters
size: Specifies the MTU in bytes. The value range for this argument is 46 to 1500.
Examples
# Set the MTU of Layer 3 aggregate interface Route-Aggregation 1 to 1430 bytes.
<Sysname> system-view
[Sysname] interface route-aggregation 1
[Sysname-Route-Aggregation1] mtu 1430
Related commands
display interface
port link-aggregation group
Use port link-aggregation group to assign the Ethernet interface to the specified aggregation group.
Use undo port link-aggregation group to remove the Ethernet interface from the aggregation group to
which it belongs.