F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices High Availability Command Reference-6PW100

140
Default
Switchover delays on the active and standby interfaces are 0, indicating immediate switchover without
any delay.
Views
Interface view
Default command level
2: System level
Parameters
enable-delay: Specifies switchover delay from the active interface to the standby interface. It ranges from
0 to 65535 seconds.
disable-delay: Specifies switchover delay from the standby interface to the active interface. It ranges from
0 to 65535 seconds.
Usage guidelines
This command sets the delay timer for a standby interface to startup when the active interface is down,
and the delay timer for a standby interface to be disabled after the active interface is recovered.
This command must be executed after standby interfaces are specified.
Examples
# Configure interface GigabitEthernet 0/2 to use interface GigabitEthernet 0/1 for backup, and to
experience 10 seconds of delay before switchover.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] standby interface gigabitethernet 0/2
[Sysname-GigabitEthernet0/1] standby timer delay 10 10
Related commands
standby interface
standby timer flow-check
Use standby timer flow-check to configure the interval for checking the traffic size on the active interface.
Use undo standby timer flow-check to restore the default.
Syntax
standby timer flow-check interval
undo standby timer flow-check
Default
The interval for checking the traffic size on the active interface is 30 seconds.
Views
Interface view
Default command level
2: System level