F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices High Availability Configuration Guide-6PW100

97
Figure 48 Checking the status of Collaboration Group 1's member ports
41B
Configuring a collaboration group at the CLI
135BConfiguring a collaboration group
Perform the following operation on multiple interfaces to add them to a collaboration group.
An interface can belong to only one collaboration group. A collaboration group can have at most eight
interfaces.
When a device is connected to another device through multiple ports, do not assign these ports to the
same collaboration group. Otherwise, when one port goes down, its peer port on the remote device may
be set to the linkgroup-down state. In that case, all the ports may fail to be brought up.
To configure a collaboration group:
Ste
p
Command Remarks
Enter system view. system-view N/A
Enter interface view. interface interface-type interface-number N/A
Add the interface to the
specified collaboration
group.
link-group link-group-number
By default, an interface does
not belong to any
collaboration group.
136BDisplaying and maintaining collaboration group
Task Command Remarks
Display the collaboration
group information
display link-group [ number
link-group-number | brief ] [ | { begin
| exclude | include }
regular-expression ]
Available in any view.
