F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices High Availability Configuration Guide-6PW100

108
NOTE:
The display nqa history command does not show the results of the UDP jitter operation. Use the display
nqa result command to display the results, or use the display nqa statistics command to display the
statistics of the operation.
147BConfiguring an SNMP operation
An SNMP operation measures the time the NQA client uses to get a value from an SNMP agent.
To configure an SNMP operation:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an NQA operation
and enter NQA operation
view.
nqa entry admin-name
operation-tag
By default, no NQA operation is
created.
3. Specify the SNMP type and
enter its view.
type snmp N/A
4. Configure the destination
address of SNMP packets.
destination ip ip-address
By default, no destination IP
address is configured.
5. Specify the source port of
SNMP packets.
source port port-number
Optional.
By default, no source port number
is specified.
6. Configure the source IP
address of SNMP packets.
source ip ip-address
Optional.
By default, no source IP address is
specified.
The source IP address must be the
IP address of a local interface. The
local interface must be up.
Otherwise, no SNMP packets can
be sent out.
148BConfiguring a TCP operation
A TCP operation measures the time the NQA client uses to establish a TCP connection to a specific port
on the NQA server.
The TCP operation requires both the NQA server and the NQA client. Before you perform a TCP
operation, configure a TCP listening service on the NQA server. For more information about the TCP
listening service configuration, see "
554HConfiguring the NQA server."
To configure a TCP operation:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Create an NQA operation
and enter NQA operation
view.
nqa entry admin-name
operation-tag
By default, no NQA operation is
created.