F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices High Availability Configuration Guide-6PW100

146
You can choose one or any combination of the following criteria for load sharing:
• Source/Destination service port numbers
• Source/Destination IP addresses
• Protocol numbers
You can also load balance traffic on a per-packet basis.
49B
Configuration restrictions and guidelines
Follow these guidelines when you configure a link aggregation group:
• To ensure stable aggregation state and service continuity, do not change port attributes or class-two
configurations on any member port. If you must, make sure you understand its impact on the live
network. Any port attribute or class-two configuration change might affect the aggregation state of
link aggregation member ports and ongoing traffic.
• Avoid assigning ports to a static aggregation group that has reached the limit on Selected ports.
These ports will be placed in Unselected state to avoid traffic interruption on the current Selected
ports. However, a device reboot can cause the aggregation state of member ports to change.
50B
Configuring Ethernet link aggregation in the Web
interface
NOTE:
Only Layer 2 static aggregation groups can be configured in the Web interface.
174BConfiguring a Layer 2 static aggregation group
1. Select Network > Link Aggregation from the navigation tree.
2. Click Create.