F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices High Availability Configuration Guide-6PW100
152
Task Remarks
593H
Configuring load-sharing criteria for link aggregation groups:
• 594HConfiguring the global link-aggregation load sharing criteria
• 595HConfiguring group-specific load sharing criteria
Optional.
178BConfiguring an aggregation group
You can choose to create a Layer 2 or Layer 3 link aggregation group depending on the ports to be
aggregated:
• To aggregate Layer 2 Ethernet interfaces, create a Layer 2 link aggregation group.
• To aggregate Layer 3 Ethernet interfaces, create a Layer 3 link aggregation group.
352BConfiguration guidelines
• You cannot assign a port to a Layer 2 aggregation group if any of the features listed in 596HTable 12 is
configured on the port.
Table 12 Features incompatible with Layer 2 aggregation groups
Feature Reference
Packet filtering Firewall in Attack Prevention Configuration Guide.
Ports specified as source interfaces
in portal-free rules
Portal in Access Control Configuration Guide.
• You cannot assign a port to a Layer 3 aggregation group if any of the features listed in 597HTable 13 is
configured on the port.
Table 13 Interfaces that cannot be assigned to a Layer 3 aggregation group
Interface t
yp
e Reference
Interfaces configured with IP addresses IP addressing in Network Management Configuration Guide.
Interfaces configured as DHCP/BOOTP
clients
DHCP in Network Management Configuration Guide.
VRRP VRRP in High Availability Configuration Guide
Portal Portal in Access Control Configuration Guide.
• Interfaces configured with static MAC addresses can join a aggregation group.
• Removing an aggregate interface also removes its aggregation group. At the same time, all
member ports leave the aggregation group.
353BConfiguring a Layer 2 static aggregation group
To guarantee a successful static aggregation, make sure the ports at both ends of each link are in the
same aggregation state.
To configure a Layer 2 static aggregation group:
Ste
p
Command
Remarks
1. Enter system view.
system-view N/A