F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices High Availability Configuration Guide-6PW100

154
Ste
p
Command Remarks
5. Assign the port an
aggregation priority.
link-aggregation port-priority
port-priority
Optional.
By default, the aggregation priority
of a port is 32768.
When the number of ports eligible
for becoming Selected ports
exceeds the maximum number of
Selected ports allowed in a static
aggregation group, changing the
aggregation priority of a port may
affect the aggregation state of the
ports in the static aggregation
group.
355BConfiguring a Layer 2 dynamic aggregation group
To guarantee a successful dynamic aggregation, make sure the peer ports of the ports aggregated at
one end are also aggregated. The two ends can automatically negotiate the aggregation state of each
member port.
To configure a Layer 2 dynamic aggregation group:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Set the system LACP priority.
lacp system-priority system-priority
Optional.
By default, the system LACP priority
is 32768.
Changing the system LACP priority
might affect the aggregation state
of the ports in a dynamic
aggregation group.
3. Create a Layer 2 aggregate
interface and enter Layer 2
aggregate interface view.
interface bridge-aggregation
interface-number
When you create a Layer 2
aggregate interface, the system
automatically creates a Layer 2
static aggregation group
numbered the same.
4. Configure the aggregation
group to operate in dynamic
aggregation mode.
link-aggregation mode dynamic
By default, an aggregation group
operates in static aggregation
mode.
5. Exit to system view.
quit N/A
6. Assign a Layer 2 Ethernet
interface to the aggregation
group.
a. interface interface-type
interface-number
b. port link-aggregation
group number
Repeat these two sub-steps to
assign more Layer 2 Ethernet
interfaces to the aggregation
group.