F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices High Availability Configuration Guide-6PW100

156
Ste
p
Command Remarks
7. Assign the port an
aggregation priority.
link-aggregation port-priority
port-priority
Optional.
By default, the aggregation priority
of a port is 32768.
When the number of ports eligible
for becoming Selected ports
exceeds the maximum number of
Selected ports allowed in a
dynamic aggregation group,
changing the aggregation priority
of a port may affect the
aggregation state of ports in the
dynamic aggregation group.
8. Set the LACP timeout interval
on the port to the short timeout
interval (1 second).
lacp period short
Optional.
By default, the LACP timeout
interval on a port is the long
timeout interval (30 seconds).
179BConfiguring an aggregate interface
Most of the configurations that can be performed on Layer 2 or Layer 3 Ethernet interfaces can also be
performed on Layer 2 or Layer 3 aggregate interfaces.
357BConfiguring the description of an aggregate interface or subinterface
You can configure the description of an aggregate interface for administration purposes such as
describing the purpose of the interface.
To configure the description of an aggregate interface or subinterface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter aggregate
interface view.
• Enter Layer 2 aggregate interface
view:
interface bridge-aggregation
interface-number
• Enter Layer 3 aggregate interface
or subinterface view:
interface route-aggregation
{ interface-number |
interface-number.subnumber }
Use either command.
3. Configure the
description of the
aggregate interface or
subinterface.
description text
Optional.
By default, the description of an
interface is in the format of
interface-name Interface, such as
Bridge-Aggregation1 Interface.
358BConfiguring the MTU of a Layer 3 aggregate interface or subinterface
The MTU of an interface affects IP packets fragmentation and reassembly on the interface.