F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices High Availability Configuration Guide-6PW100

159
Ste
p
Command Remarks
4. Set the maximum number of
Selected ports for the
aggregation group.
link-aggregation selected-port
maximum number
By default, the maximum number of
Selected ports for an aggregation
group depends on the hardware
capabilities of the member ports.
361BShutting down an aggregate interface
Shutting down or bringing up an aggregate interface affects the aggregation state and link state of
aggregated member ports in the following ways:
• When an aggregate interface is shut down, all Selected member ports become unselected and
their link state becomes down. Shutting down a Layer 3 aggregate subinterface does not affect any
aggregation group, because Layer 3 aggregate subinterfaces are not associated with any
aggregation groups.
• When an aggregate interface is brought up, the aggregation state of member ports is recalculated
and their link state becomes up.
To shut down an aggregate interface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter aggregate interface
view.
• Enter Layer 2 aggregate
interface view:
interface bridge-aggregation
interface-number
• Enter Layer 3 aggregate
interface view:
interface route-aggregation
interface-number
Use either command.
3. Shut down the aggregate
interface or subinterface.
shutdown
By default, aggregate interfaces or
subinterfaces are up.
362BRestoring the default settings for an aggregate interface
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter aggregate interface
view.
• Enter Layer 2 aggregate interface
view:
interface bridge-aggregation
interface-number
• Enter Layer 3 aggregate interface
view:
interface route-aggregation
interface-number
Use either command.
3. Restore the default settings for
the aggregate interface or
subinterface.
default N/A