F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices High Availability Configuration Guide-6PW100

160
180BConfiguring load-sharing criteria for link aggregation groups
You can determine how traffic is load-shared in a link aggregation group by configuring load-sharing
criteria. The criteria can be source/destination service port numbers, source/destination IP addresses, or
protocol numbers carried in packets, or any combination. You can also perform per-packet load sharing.
You can configure global or group-specific load-sharing criteria. A link aggregation group preferentially
uses the group-specific load-sharing criteria. If no group-specific load-sharing criteria is available, the
group uses the global load-sharing criteria.
363BConfiguring the global link-aggregation load sharing criteria
Ste
p
Command Remarks
1. Enter system view.
system-view
N/A
2. Configure the global
link-aggregation
load-sharing criteria.
link-aggregation load-sharing mode
{ { destination-ip | destination-port |
ip-protocol | source-ip | source-port } *
| per-packet }
By default, destination-ip,
destination-port, ip-protocol,
source-ip, and source-port are
enabled.
364BConfiguring group-specific load sharing criteria
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter aggregate interface
view.
• Enter Layer 2 aggregate interface
view:
interface bridge-aggregation
interface-number
• Enter Layer 3 aggregate interface
view:
interface route-aggregation
interface-number
Use either command.
3. Configure the load-sharing
criteria for the aggregation
group.
link-aggregation load-sharing mode
{ { destination-ip | destination-port |
ip-protocol | source-ip | source-port } *
| per-packet }
By default, destination-ip,
destination-port, ip-protocol,
source-ip, and source-port are
enabled.
181BDisplaying and maintaining Ethernet link aggregation
Task Command Remarks
Display information about
aggregate interfaces.
display interface [ bridge-aggregation |
route-aggregation ] [ brief [ down ] ] [ | { begin
| exclude | include } regular-expression ]
display interface { bridge-aggregation |
route-aggregation } interface-number [ brief ] [ |
{ begin | exclude | include } regular-expression ]
Available in any
view.
Display the local system ID.
display lacp system-id [ | { begin | exclude |
include } regular-expression ]
Available in any
view.