F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices High Availability Configuration Guide-6PW100

161
Task Command Remarks
Display the global or
group-specific link-aggregation
load-sharing criteria.
display link-aggregation load-sharing mode
[ interface [ { bridge-aggregation |
route-aggregation } interface-number ] ] [ |
{ begin | exclude | include } regular-expression ]
Available in any
view.
Display detailed link aggregation
information for link aggregation
member ports.
display link-aggregation member-port
[ interface-list ] [ | { begin | exclude | include }
regular-expression ]
Available in any
view.
Display summary information
about all aggregation groups.
display link-aggregation summary [ | { begin |
exclude | include } regular-expression ]
Available in any
view.
Display detailed information about
a specific or all aggregation
groups.
display link-aggregation verbose
[ { bridge-aggregation | route-aggregation }
[ interface-number ] ] [ | { begin | exclude |
include } regular-expression ]
Available in any
view.
Clear LACP statistics for a specific
or all link aggregation member
ports.
reset lacp statistics [ interface interface-list ]
Available in user
view.
Clear statistics for a specific or all
aggregate interfaces.
reset counters interface [ { bridge-aggregation |
route-aggregation } [ interface-number ] ]
Available in user
view.
182BEthernet link aggregation configuration examples
In an aggregation group, only ports that have the same port attributes and class-two configurations (see
"
598HConfiguration classes") as the reference port (see "599HReference port") can operate as Selected ports.
Make sure all member ports have the same port attributes and class-two configurations as the reference
port. The other settings only need to be configured on the aggregate interface, not on the member ports.
365BLayer 2 static aggregation configuration example
1. Network requirements
As shown in
600HFigure 72, configure a Layer 2 static aggregation group on Firewall A and Firewall
B. Enable VLAN 10 at one end of the aggregate link to communicate with VLAN 10 at the other
end, and enable VLAN 20 at one end to communicate with VLAN 20 at the other end.
Enable traffic to be load-shared across aggregation group member ports based on the source and
destination IP addresses.