F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices High Availability Configuration Guide-6PW100

166
# Create Layer 2 aggregate interface Bridge-Aggregation 1, and configure the load sharing
criterion for the link aggregation group as the source IP addresses of packets.
[FirewallA] interface bridge-aggregation 1
[FirewallA-Bridge-Aggregation1] link-aggregation load-sharing mode source-ip
[FirewallA-Bridge-Aggregation1] quit
# Assign ports GigabitEthernet 0/1 and GigabitEthernet 0/2 to link aggregation group 1.
[FirewallA] interface gigabitethernet 0/1
[FirewallA-GigabitEthernet0/1] port link-aggregation group 1
[FirewallA-GigabitEthernet0/1] quit
[FirewallA] interface gigabitethernet 0/2
[FirewallA-GigabitEthernet0/2] port link-aggregation group 1
[FirewallA-GigabitEthernet0/2] quit
# Configure Layer 2 aggregate interface Bridge-Aggregation 1 as a trunk port and assign it to
VLAN 10.
[FirewallA] interface bridge-aggregation 1
[FirewallA-Bridge-Aggregation1] port link-type trunk
[FirewallA-Bridge-Aggregation1] port trunk permit vlan 10
Please wait... Done.
Configuring GigabitEthernet0/1... Done.
Configuring GigabitEthernet0/2... Done.
[FirewallA-Bridge-Aggregation1] quit
# Create Layer 2 aggregate interface Bridge-Aggregation 2, and configure the load sharing
criterion for the link aggregation group as the destination IP addresses of packets.
[FirewallA] interface bridge-aggregation 2
[FirewallA-Bridge-Aggregation2] link-aggregation load-sharing mode
destination-ip
[FirewallA-Bridge-Aggregation2] quit
# Assign ports GigabitEthernet 0/3 and GigabitEthernet 0/4 to link aggregation group 2.
[FirewallA] interface gigabitethernet 0/3
[FirewallA-GigabitEthernet0/3] port link-aggregation group 2
[FirewallA-GigabitEthernet0/3] quit
[FirewallA] interface gigabitethernet 0/4
[FirewallA-GigabitEthernet0/4] port link-aggregation group 2
[FirewallA-GigabitEthernet0/4] quit
# Configure Layer 2 aggregate interface Bridge-Aggregation 2 as a trunk port and assign it to
VLAN 20.
[FirewallA] interface bridge-aggregation 2
[FirewallA-Bridge-Aggregation2] port link-type trunk
[FirewallA-Bridge-Aggregation2] port trunk permit vlan 20
Please wait... Done.
Configuring GigabitEthernet0/3... Done.
Configuring GigabitEthernet0/4... Done.
[FirewallA-Bridge-Aggregation2] quit
b. Configure Firewall B in the same way as you configure Firewall A. (Details not shown.)
c. Verify the configurations:
# Display summary information about all aggregation groups on Firewall A.
[FirewallA] display link-aggregation summary