F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices High Availability Configuration Guide-6PW100

171
[FirewallA] interface gigabitethernet 0/3
[FirewallA-GigabitEthernet0/3] port link-aggregation group 2
[FirewallA-GigabitEthernet0/3] quit
[FirewallA] interface gigabitethernet 0/4
[FirewallA-GigabitEthernet0/4] port link-aggregation group 2
[FirewallA-GigabitEthernet0/4] quit
b. Configure Firewall B in the same way as you configure Firewall A. (Details not shown.)
c. Verify the configuration:
# Display summary information about all aggregation groups on Firewall A.
[FirewallA] display link-aggregation summary
Aggregation Interface Type:
BAGG -- Bridge-Aggregation, RAGG -- Route-Aggregation
Aggregation Mode: S -- Static, D -- Dynamic
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor System ID: 0x8000, 000f-e2ff-0001
AGG AGG Partner ID Select Unselect Share
Interface Mode Ports Ports Type
------------------------------------------------------------------------------
-
RAGG1 S none 2 0 Shar
RAGG2 S none 2 0 Shar
The output shows that link aggregation groups 1 and 2 are both load-shared Layer 3 static
aggregation groups and each contains two Selected ports.
# Display all the group-specific load-sharing criteria on Firewall A.
[FirewallA] display link-aggregation load-sharing mode interface
Route-Aggregation1 Load-Sharing Mode:
source-ip address
Route-Aggregation2 Load-Sharing Mode:
destination-ip address
The output shows that the load sharing criterion for link aggregation group 1 is the source IP
address and the load sharing criterion for link aggregation group 2 is the destination IP
address.