F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices High Availability Configuration Guide-6PW100

209
Figure 110 Adding a physical link
3. Configure the parameters as described in 649HTable 20.
4. Click Apply.
Table 20 Configuration items
Item Descri
p
tion
Physical Link Name Set the physical link name, which uniquely identifies a physical link.
NextHop Specify the IP address of the next hop corresponding to the physical link.
Health Monitoring Type Select a health monitoring method to monitor a physical link.
Health Monitoring Success
Criteria
Specify the health monitoring success criteria.
• If you select All, health monitoring succeeds only when all the selected
health monitoring methods succeed.
• If you select At Least and specify a value, health monitoring succeeds
when the number of succeeded health monitoring methods reaches the
specified value.
Health Monitoring Type
Health monitoring type of the physical link:
• ICMP—Detects the reachability of the next hop of the physical link
through ICMP messages.
• TCP Half Open—Detects the reachability of the next hop of the physical
link through a TCP half open connection.
Uplink BandWidth Maximum uplink bandwidth allowed by the physical link.
Uplink BandWidth Busy Rate
When the percentage of the actual uplink bandwidth of a physical link to
maximum uplink bandwidth reaches this busy rate, the physical link is
busy.
Downlink BandWidth Maximum downlink bandwidth allowed by the physical link.