F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices High Availability Configuration Guide-6PW100

30
3. Verify the configuration:
After the configuration, Host B can be pinged successfully on Host A. To verify your configuration,
use the display vrrp verbose command.
# Display the detailed information about VRRP group 1 on Firewall A.
[FirewallA-GigabitEthernet0/1] display vrrp verbose
IPv4 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 1
Interface GigabitEthernet0/1
VRID : 1 Adver Timer : 1
Admin Status : Up State : Master
Config Pri : 110 Running Pri : 110
Preempt Mode : Yes Delay Time : 5
Auth Type : None
Virtual IP : 202.38.160.111
Virtual MAC : 0000-5e00-0101
Master IP : 202.38.160.1
# Display the detailed information about VRRP group 1 on Firewall B.
[FirewallB-GigabitEthernet0/1] display vrrp verbose
IPv4 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 1
Interface GigabitEthernet0/1
VRID : 1 Adver Timer : 1
Admin Status : Up State : Backup
Config Pri : 100 Running Pri : 100
Preempt Mode : Yes Delay Time : 5
Become Master : 4200ms left
Auth Type : None
Virtual IP : 202.38.160.111
Master IP : 202.38.160.1
The output shows that in VRRP group 1 Firewall A is the master, Firewall B is the backup and
packets sent from Host A to Host B are forwarded by Firewall A.
If Firewall A fails, you can still ping Host B successfully on Host A. To view the detailed information
about the VRRP group on Firewall B, use the display vrrp verbose command.
# If Firewall A fails, display the detailed information about VRRP group 1 on Firewall B.
[FirewallB-GigabitEthernet0/1] display vrrp verbose
IPv4 Standby Information:
Run Mode : Standard
Run Method : Virtual MAC
Total number of virtual routers : 1
Interface GigabitEthernet0/1
VRID : 1 Adver Timer : 1
Admin Status : Up State : Master
Config Pri : 100 Running Pri : 100