F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices NAT and ALG Command Reference-6PW100

11
Table 7 Command output
Field Descri
p
tion
total PAT session table count Number of PAT session entries.
total NO-PAT session table count Number of NO-PAT session entries.
total SERVER session table count Number of SERVER session entries.
total STATIC session table count Number of STATIC session entries.
nat address-group
Use nat address-group to configure a NAT address pool. When the start and end IP addresses are
specified, this command specifies an address pool. Without the start and end IP addresses specified, the
command places you into the address group view.
Use undo nat address-group to remove an address pool or address group.
Syntax
nat address-group group-number [ start-address end-address [ level level ]]
undo nat address-group group-number [ start-address end-address [ level level ]]
Views
System view
Default command level
2: System level
Parameters
group-number: Index of the address pool.
The following matrix shows the value range for the group-number argument on different firewalls and
UTM devices:
Hardware Value ran
g
e
F1000-A-EI/F1000-S-EI 0 to 255
F1000-E 0 to 255
F5000 0 to 255
Firewall module 0 to 255
U200-A 0 to 255
U200-S 0 to 31
start-address: Start IP address of the address pool.
end-address: End IP address of the address pool. The end-address cannot be lower than the start-address.
If they are the same, the address pool has only one IP address. The maximum number of IP addresses that
can be added to an address pool is 255.
level level: Specifies the level of port numbers assigned in NAPT translation for this address pool. It takes
the value of either 1 or 0. 0 represents a lower level, and the assignable port numbers range from 35000
to 65535. 1 represents a higher level, and the assignable port numbers range from 1024 to 34999 for