F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

1007
Syntax
probe-interval interval
undo probe-interval
Default
The register probe time is 5 seconds.
Views
IPv6 PIM view
Default command level
2: System level
Parameters
interval: Specifies a register probe time in seconds. The value ranges from 1 to 1799.
Examples
# Set the register probe time to 6 seconds.
<Sysname> system-view
[Sysname] pim ipv6
[Sysname-pim6] probe-interval 6
Related commands
register-suppression-timeout
prune delay (IPv6 PIM view)
Use prune delay to set the prune delay timer (namely, the time that the device waits between receiving
a prune message and taking a prune action).
Use undo prune delay to restore the default.
Syntax
prune delay interval
undo prune delay
Default
No prune delay timer is set.
Views
IPv6 PIM view
Default command level
2: System level
Parameters
interval: Specifies a prune delay timer in seconds, in the range 1 to 128.
Examples
# Set the prune delay timer to 75 seconds on the public network.
<Sysname> system-view
[Sysname] pim ipv6