F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

1037
Default command level
2: System level
Parameters
interval: Specifies the maximum response time for MLD general query messages in seconds, in the range
of 1 to 25.
Usage guidelines
The maximum response time determines the time which the device takes to detect directly attached group
members in the LAN.
Examples
# Set the maximum response delay for MLD general query messages to 8 seconds on GigabitEthernet
0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] mld max-response-time 8
Related commands
• display mld interface
• max-response-time
• mld timer other-querier-present
mld proxying enable
Use mld proxying enable to enable MLD proxying on an interface.
Use undo mld proxying enable to disable MLD proxying on the interface.
Syntax
mld proxying enable
undo mld proxying enable
Default
MLD proxying is disabled.
Views
Interface view
Default command level
2: System level
Usage guidelines
This command takes effect only after IPv6 multicast routing is enabled.
If MLD proxying is enabled on a loopback interface, the proxy device maintains only the MLD routing
table without adding the MLD routes to the multicast routing table and forwarding table.
Examples
# Enable IPv6 multicast routing and enable MLD proxying on GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] multicast ipv6 routing-enable