F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

1064
Usage guidelines
If you have set preferences for routing protocols with the preference command, using the apply
preference command sets a new preference for the matching routing protocol. Non-matching routing
protocols still use the preferences set by the preference command.
Examples
# Configure node 10 in permit mode of routing policy policy1. Set the preference for OSPF external
routes to 90.
<Sysname> system-view
[Sysname] route-policy policy1 permit node 10
[Sysname-route-policy] if-match route-type external-type1or2
[Sysname-route-policy] apply preference 90
apply preferred-value
Use apply preferred-value to set a preferred value for BGP routes.
Use undo apply preferred-value to remove the clause configuration.
Syntax
apply preferred-value preferred-value
undo apply preferred-value
Default
No preferred value is set for BGP routes.
Views
Routing policy view
Default command level
2: System level
Parameters
preferred-value: Preferred value, in the range of 0 to 65535.
Usage guidelines
The following matrix shows the apply preferred-value command and firewalls and UTM devices
compatibility:
Hardware Command com
p
atible
F1000-A-EI/F1000-S-EI Yes
F1000-E Yes
F5000 Yes
Firewall module Yes
U200-A Yes
U200-S No