F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

90
Views
MST region view
Default command level
2: System level
Parameters
name: Specifies the MST region name, a string of 1 to 32 characters.
Usage guidelines
The MST region name, the VLAN-to-instance mapping table, and the MSTP revision level of a device
determine the device's MST region.
After configuring this command, run the active region-configuration command to activate the configured
MST region name.
Examples
# Set the MST region name of the device to hello.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] region-name hello
Related commands
• active region-configuration
• check region-configuration
• display stp region-configuration
• instance
• revision-level
• vlan-mapping modulo
reset stp
Use reset stp to clear the MSTP statistics information.
Syntax
reset stp [ interface interface-list ]
Views
User view
Default command level
1: Monitor level
Parameters
interface interface-list: Clears the MSTP statistics of the ports specified in the format of interface-list =
{ interface-type interface-number [ to interface-type interface-number ] }&<1-10>, where &<1-10>
indicates that you can specify up to 10 interface-type interface-number [ to interface-type
interface-number ] parameters. If you don’t specify this option, the command clears the spanning
tree-related statistics on all ports.